This filter is perfect for seamlessly inserting knots into woodgrains, as it warps the grain around a specific point. This can make editing these types of designs quick and easy, and the knots look like they have always been there!
Instructions
- Open the Filter Browser, and add a new filter set using the small + icon located in the middle of the browser. This will create a new ‘untitled’ filter set for you. This will appear in the top section of the Filter Browser. If you already have filter sets created, clicking the + button will duplicate the selected filter set.
- Select Hole Distortion from the list of available filters in the lower section of the Filter Browser.
- Double click on the name of the new filter set in the top section of the browser, and name it appropriately.
- Click the Pin icon under the Radius and Scale variables.
Edit the Radius until you achieve the desired result. In the snapshot below, the original data is on the left, and the filtered data is on the right.
- Edit the Radius until you achieve the desired result. In the image below, the original data is on the left, and the filtered data is on the right.
Applying the filter
There are several ways to apply a filter:
- Click Apply - this will apply the filter to the active layer(s), and within a selection if there is one present in your file
- Click Make Layer - this will make a new layer in your file containing the filtered effect, leaving the original layer untouched
- Apply the filter using the Brush Tool - when you have finished building your filter set, simply close the Filter Browser. Then, open the Brushes Library, and select the filter you have just made from the drop down menu shown in the snapshot below. You can now paint with your filter.
Applying the filter over a repeat join
For a full explanation on how to use filters, view the Filter Browser article. Each individual filter is further explained in it's own article and can be searched on in the search bar above.
Some of the filters do not work correctly across repeat joins when used in the normal way. Therefore it is important to follow this method to make sure the filter works correctly and does not affect the join. Your design must repeat correctly before you do this.
- Open the Selections Palette.
- Press Offset Repeat. If you are not already viewing multiple repeats of your design, AVA will automatically put your design into s 2x2 repeat when you press this. A selection the size of a single repeat will appear in your file, offset to the first repeat, which is framed in blue in the snapshot below.
- Activate the layer / image you want to filter.
- Open the Filter Browser.
- Apply your the filter. The filter will work correctly in repeat, with no obvious repeat joins. In the image below, the vertical line is the repeat join.